A basic question:
I have to reduce the height of some forged aluminum pistons and I think I'll use my lathe.
Since the diameter will vary greatly (4.375" down to 0") as I make the cut, and I have to choose a fixed speed, what's a good recommendation for speed (and feed) to get a good finish?
Thanks.
I have to reduce the height of some forged aluminum pistons and I think I'll use my lathe.
Since the diameter will vary greatly (4.375" down to 0") as I make the cut, and I have to choose a fixed speed, what's a good recommendation for speed (and feed) to get a good finish?
Thanks.