adam eldridge
Plastic
- Joined
- Nov 4, 2011
- Location
- Columbus, OH
Hello.
We're attempting to increase production volume. Currently we run a single miter system (one miter at a time) on a bridgeport.
Ideally we'd like to design a fixture to plunge two hole saws at different angles through the front and rear of the tube at the same time.
Please if you have any knowledge of where to start send me a note. I really appreciate it.
Adam
We're attempting to increase production volume. Currently we run a single miter system (one miter at a time) on a bridgeport.
Ideally we'd like to design a fixture to plunge two hole saws at different angles through the front and rear of the tube at the same time.
Please if you have any knowledge of where to start send me a note. I really appreciate it.
Adam