amatureracer07
Plastic
- Joined
- Feb 20, 2012
- Location
- Wisconsin, USA
Hello,
I'm new here, hope this is the right place to post this...
I recently purchased a used Bridgeport mill that has an Anilam Wizard 350 DRO on it, not the 350 plus which is referenced both on the Anilam site and pretty much everywhere else. The non-plus version is apparently quite different.
Does anybody know where I can find a user/operators manual for this unit? It seems as though Anilam no longer exists, and the email links seem to all be dead on their site. I have also been trying to find info on the linear encoders which seem to be quite antiquated as well. It has a KM5 on the Y-axis and a B5 on the X-axis, both Anilam brand.
Any help would be greatly appreciated.
Thank you,
David
I'm new here, hope this is the right place to post this...
I recently purchased a used Bridgeport mill that has an Anilam Wizard 350 DRO on it, not the 350 plus which is referenced both on the Anilam site and pretty much everywhere else. The non-plus version is apparently quite different.
Does anybody know where I can find a user/operators manual for this unit? It seems as though Anilam no longer exists, and the email links seem to all be dead on their site. I have also been trying to find info on the linear encoders which seem to be quite antiquated as well. It has a KM5 on the Y-axis and a B5 on the X-axis, both Anilam brand.
Any help would be greatly appreciated.
Thank you,
David
