hornluv
Aluminum
- Joined
- Oct 20, 2005
- Location
- Champaign-Urbana, Illinois
Does anybody have some good pictures of your Bridgeport or similar mill being lifted? I want to get mine off the pallet I made for it but the engine hoist I have just won't lift it high enough (the back side comes up but the knee side stays down). I'm trying to lift it with lifting straps around the ram wrapped up in a basket type weave. Every other weave I've tried ends up being too long and I run out of travel on the hoist. I don't have a suitable eye bolt for the lifting point, but I'm going to look for one tomorrow. I don't have a forklift or anything like it. I can't imagine I'd be able to use one anyway as my ceiling is low. Any other ideas?
Thanks,
Stuart
Thanks,
Stuart