I appologize if this question is not in the right section or group. I'm looking for a way to clean stamping oil (Tuff Draw) off parts right off a stamping press. Nothing perfectly clean, but enough so they can be heat treated and not bother that step. The parts are Stainless steel, under 4" diameter, thickness is .035-.188, they are relativley flat, the press runs around 80 strokes per minute The parts come out on a shaker. I'd like to put something at the end of the press like a wash system? Something hands off. Any thoughts or suggestions?
I was thinking this:MPW Mini Parts Washer,
Thanks in advance.
-Mike
I was thinking this:MPW Mini Parts Washer,
Thanks in advance.
-Mike