I need a couple of chuck mounting plates to mount tooling to my Weiler LZ330
The DIN 800 60X4 nose requires a spigot length of over an inch (two inch total thickness) and an OD of just over 3 1/8th inch to accommodate the clamping ring.
7 inch size would be just right
This is on line link popped up
Rough Cast Adapters for Plain Back Chucks (WT)
Can anyone make a suggestion of alternative economical sources?
The DIN 800 60X4 nose requires a spigot length of over an inch (two inch total thickness) and an OD of just over 3 1/8th inch to accommodate the clamping ring.
7 inch size would be just right
This is on line link popped up
Rough Cast Adapters for Plain Back Chucks (WT)
Can anyone make a suggestion of alternative economical sources?