benfica
Plastic
- Joined
- Dec 26, 2010
- Location
- Springfield, MO, USA
Hey folks,
New to the forum but reading the stuff up here for a couple years now.
So, I have a Enco 110-1340 and selling it and bought a Clausing 5914, with taper attachment, original motor (will install a VFD), Burnerd 4 Jaw 8" Chuck, LOO Collet Chuck w/12 Multisize Collets, collet closer, etc, etc.
I need to have a chuck installed on the rear of spindle bore.
On the Enco I have, the spindle bore is threaded so I asked my machinist to do a threaded sleeve and installed it on the spindle bore. The sleeve has a 3 jaw self centering chuck with 1 3/8" opening.
The Clausing spindle bore is not threaded...
I heard that there are chucks that you can install on the rear of spindle bore. I need a minimum of 1 3/8' opening.
What suggestions do you folks have?
I know I can probable do some delrin collets but I am looking to get within less than a 0.001 runout on the front and back chucks.
New to the forum but reading the stuff up here for a couple years now.
So, I have a Enco 110-1340 and selling it and bought a Clausing 5914, with taper attachment, original motor (will install a VFD), Burnerd 4 Jaw 8" Chuck, LOO Collet Chuck w/12 Multisize Collets, collet closer, etc, etc.
I need to have a chuck installed on the rear of spindle bore.
On the Enco I have, the spindle bore is threaded so I asked my machinist to do a threaded sleeve and installed it on the spindle bore. The sleeve has a 3 jaw self centering chuck with 1 3/8" opening.
The Clausing spindle bore is not threaded...
I heard that there are chucks that you can install on the rear of spindle bore. I need a minimum of 1 3/8' opening.
What suggestions do you folks have?
I know I can probable do some delrin collets but I am looking to get within less than a 0.001 runout on the front and back chucks.