I picked up a nice Aloris CA tool post with quite a few tool holders today. It shows as being for 14 - 20" swing lathes. The T is just slightly too big to fit my old Reed Prentice 16" lathes compound.
Can the T-nut be switched out to fit a smaller compound t-slot or is this not reccomended? I checked the Aloris site but could not find anything about this.
Thanks,
Andrew
Can the T-nut be switched out to fit a smaller compound t-slot or is this not reccomended? I checked the Aloris site but could not find anything about this.
Thanks,
Andrew