Aaron T. Young
Plastic
- Joined
- Nov 20, 2009
- Location
- Fresno, Ca
I am reverse engineering a 30 tooth, flat root internal spline. It has a major Dia. of: 2.75" (69.88mm), a Minor Dia of 2.574" (32.696mm), and it has a 30° Pressure Angle. I have been unable to find it in the ANSI Standards. Can anyone confirm weather or not this is a custom Spline, any advice or direction would be appreciated
Cheers,
Aaron
"The Liver is Evil it must be Punished"
Cheers,
Aaron
"The Liver is Evil it must be Punished"
Last edited: