2Slow
Hot Rolled
- Joined
- Jun 26, 2006
- Location
- South East Michigan, USA
It's time to add proper heat to the shop. I am trying to decide between three units:
Sterling RF90
Modine Hot Dawg HD125
Reznor UDAP125
I have two friends with Sterling units and they have had nothing but good luck with them. Unfortunately the largest low profile one they make is 90k BTU input and 73K BTU output. That is probably a little small for the shop, and if I had to err, I would prefer to do so on the large side.
The other two have about 100K BTU output and I think that should be just about right. Does anyone have any experience with any of the three units and have advice / preferences?
Thanks
-Joe
Sterling RF90
Modine Hot Dawg HD125
Reznor UDAP125
I have two friends with Sterling units and they have had nothing but good luck with them. Unfortunately the largest low profile one they make is 90k BTU input and 73K BTU output. That is probably a little small for the shop, and if I had to err, I would prefer to do so on the large side.
The other two have about 100K BTU output and I think that should be just about right. Does anyone have any experience with any of the three units and have advice / preferences?
Thanks
-Joe