If you look at the machining marks and the Stamping, it looks like a homemade job for something. I know this it is not any of the C1 through 7 type collets, nor is it an R8.
Do you have something that it fits? Or more than one? That might be a better clue as to what it is.
Yes. It is part of the Snap-on stud extractor system. My thought was that someone was using a 'standard' collet, threading it and had a mini holder to draw it in and then remove the stud. 4 pc Stud Remover Set (3/4"-1 –1"-8) is the part.
If I could ID the collet series, I can make any specialty ones I need...
Yes. It is part of the Snap-on stud extractor system. My thought was that someone was using a 'standard' collet, threading it and had a mini holder to draw it in and then remove the stud. 4 pc Stud Remover Set (3/4"-1–1"-8) is the part.
If I could ID the collet series, I can make any specialty ones I need...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.