Vfd trouble/confusion

hello, I just purchased a Bridgeport.

As I haven't got 3phase power I'm trying to wire up a VFD. In the picture is an Allen Bradley but the PO said it no longer worked and gave me a Huanyang.

Not a good picture but it has a label on the cover NOT in that pic says "220v/2.2kw" Ok, 22ov, got it. 2.2kw, 3 hp. Got it.

This is the motor face plate.
I'm trying to figure out what I need to program into the VFD. I have questions because I tried to put 440 into PD0142 (or PD0141) for the voltage but it only goes to 255. Does this not output 3 PH? Or should I be putting in 220 or 208? Are these motors standard wired for Hi or Low volts.

I'm sorry if these are simple answers or if I'm totally off base but I can't find specific answers. And I don't want to burn anything up.

possum

Put in what you input voltage is. 240 single phase input, 240v output 3 phase. Don't worry about your motor being shown as 220 instead of 240. CHECK you motor wiring - can he either high or low. Wire to your input voltage.