dwblake
Plastic
- Joined
- Dec 18, 2017
- Location
- Post Falls, Idaho, USA
I have a client who has bought in a Browning Buckmark. When fired the firing pin just barely hit the edge of the round. I have changed firing pins, firing pin spring, extractors and extractor springs with no luck on correcting the issue. I stretched the new firing pin about ten thousands of an inch, which helped. It strikes harder but still only hits the very edge of the round and miss fires quit often. I am at my wits end on how to get this thing to strike more on the back of the round then just barely on the edge. Any suggestions?