huntgrouse
Plastic
- Joined
- Jan 15, 2007
- Location
- New York State
I am a new member so this has probably been hased out before but here goes.
Has anyone had any experience with Grizzly machines?
Specifically the G0554 14" x 40" Lathe and the G9902 9" x 49" Vertical Mill w/ Power Feed & Single-Phase
looking at adding soem equipment and these seem to be pretty well set up. I would add DRO to both.
I have a Clausing 12x36 and Clausing mill but they are getting on in years.
I am a gunsmith 25+ years) and use these two machines regularly.
Thoughts, experiences???
Has anyone had any experience with Grizzly machines?
Specifically the G0554 14" x 40" Lathe and the G9902 9" x 49" Vertical Mill w/ Power Feed & Single-Phase
looking at adding soem equipment and these seem to be pretty well set up. I would add DRO to both.
I have a Clausing 12x36 and Clausing mill but they are getting on in years.
I am a gunsmith 25+ years) and use these two machines regularly.
Thoughts, experiences???