scratch built
Plastic
- Joined
- Jun 14, 2012
- Location
- CA
I have an old revolver that I would like to make a hammer strut out of some scrap titanium I have lying around.
I don't know much about Grade 5 Ti, or any other Ti for that matter. Just wondering what typical hardness is as supplied, and a preferred heat treat/condition if any? There is a steel pin going through it, so I'm want to protect against any deformation.
I don't know much about Grade 5 Ti, or any other Ti for that matter. Just wondering what typical hardness is as supplied, and a preferred heat treat/condition if any? There is a steel pin going through it, so I'm want to protect against any deformation.