Jdaniel343
Plastic
- Joined
- Dec 22, 2009
- Location
- Wyoming, USA
I am looking at possibly buying a Sheldon lathe. I was looking at a Birmingham, but would have to drive much further to pick it up and was $800 more than this lathe without all the tooling.
The guy is sending more photos and model number.
He believes it is 12 to 13" swing. By the pictures it appears to be an 11" model.
He says it has a 1-1/2" bore and 54" bed, 3 phase.
About 1200 lbs with 3 and 4 jaw chuck. It appears to be in very good condition and comes with plenty of tooling.
Is this a good machine. How about part avaliability, any problems?
Is there any particular things I should look for if purchasing this machine?
Any help would be appreciated.
The guy is sending more photos and model number.
He believes it is 12 to 13" swing. By the pictures it appears to be an 11" model.
He says it has a 1-1/2" bore and 54" bed, 3 phase.
About 1200 lbs with 3 and 4 jaw chuck. It appears to be in very good condition and comes with plenty of tooling.
Is this a good machine. How about part avaliability, any problems?
Is there any particular things I should look for if purchasing this machine?
Any help would be appreciated.