Long story short; I started my business with a Haas TM2P and upgraded to a VF4SS some time ago
All of my original parts where programmed on the TM2P and all the new stuff is programmed for the VF4SS. All of the fixtures are interchangeable and the material I cut is not sensitive to feeds/speeds. So on the VF4SS most of the surfacing operations are programmed at 700 ipm (which the machine never hits) and 7500-12000 RPM.
I would like to simply run the same new programs on the TM2P but get a"309 Max Feed Rate Alarm".... Surprisingly enough there is no issue with the RPM... Parts programmed at 12000 RPM run at 6000 RPM. But anything that exceeds the max feed rate of the TM2P gives an alarm. The amount of programs I have is in the 1000's... I really don't want to edit all the programs (although I could edit certain family's of parts)
So is there a way to default the max feed on the TM2P to 400 ipm (which the machine is rated at) for parts programmed at higher feeds? Any advice would be appreciated!
All of my original parts where programmed on the TM2P and all the new stuff is programmed for the VF4SS. All of the fixtures are interchangeable and the material I cut is not sensitive to feeds/speeds. So on the VF4SS most of the surfacing operations are programmed at 700 ipm (which the machine never hits) and 7500-12000 RPM.
I would like to simply run the same new programs on the TM2P but get a"309 Max Feed Rate Alarm".... Surprisingly enough there is no issue with the RPM... Parts programmed at 12000 RPM run at 6000 RPM. But anything that exceeds the max feed rate of the TM2P gives an alarm. The amount of programs I have is in the 1000's... I really don't want to edit all the programs (although I could edit certain family's of parts)
So is there a way to default the max feed on the TM2P to 400 ipm (which the machine is rated at) for parts programmed at higher feeds? Any advice would be appreciated!