Volitan
Hot Rolled
- Joined
- Sep 16, 2006
- Location
- Long Island, New York
Looking for opinions on this.
The Haas website doesn't say it does.
15, -rpm Spindle
They say the 40 taper needs it so it's not like they just don't mention it.
15,-rpm Spindle
So is a 30 taper holder too small to worry about it being out of balance at 15k?
The Haas website doesn't say it does.
15, -rpm Spindle
They say the 40 taper needs it so it's not like they just don't mention it.
15,-rpm Spindle
So is a 30 taper holder too small to worry about it being out of balance at 15k?