I have recently started to learn how to program/run the TL-2 at work. I ran a face,turn,chamfer program and added a threading G76 cycle. as below
G04 P1.
M08
M24
G76 X13.546 Z-25. K1.197 I0. D0.12 F2.
G00 X18.44 Z11.
The thread is or looks perfect on a pitch gauge and the od of the shaft prior to threading is 15.99mm OD. The thread i'm trying to cut is an M16x2. It appears to be very close but once threaded the O/D measures 16.2/16.3. Is there a way of programming in several spring cuts?
The manual I have dosen't really show much detail. I would be grateful for any help.
Many Thanks.
G04 P1.
M08
M24
G76 X13.546 Z-25. K1.197 I0. D0.12 F2.
G00 X18.44 Z11.
The thread is or looks perfect on a pitch gauge and the od of the shaft prior to threading is 15.99mm OD. The thread i'm trying to cut is an M16x2. It appears to be very close but once threaded the O/D measures 16.2/16.3. Is there a way of programming in several spring cuts?
The manual I have dosen't really show much detail. I would be grateful for any help.
Many Thanks.