ARB
Titanium
- Joined
- Dec 7, 2002
- Location
- Granville,NY,USA
So the old girl had a hissy fit today.
1994 VF3
I got a shuttle out of position alarm.
I started messing around with the usual things. Swapped relays and no dice. I did some other poking around and decided that maybe I had low voltage to the motor.
I checked a couple things and buttoned things up and then noticed a popped fuse at the top of the board where the relays are located.
Hmmm.
I put in a new fuse and fired up the machine and everything was cool. Did a tool change. Cool.
Power up restart and poop.
Stuck turret again.
I pulled the shuttle motor and set it up on top of the machine. And powered up the motor to see that it would work with no load. It did once. The second time I got a ground fault alarm and can't get rid of it.
Any ideas at all??
I farted with it for a few hours and had to run.
Maybe tomorrow will bring success.
1994 VF3
I got a shuttle out of position alarm.
I started messing around with the usual things. Swapped relays and no dice. I did some other poking around and decided that maybe I had low voltage to the motor.
I checked a couple things and buttoned things up and then noticed a popped fuse at the top of the board where the relays are located.
Hmmm.
I put in a new fuse and fired up the machine and everything was cool. Did a tool change. Cool.
Power up restart and poop.
Stuck turret again.
I pulled the shuttle motor and set it up on top of the machine. And powered up the motor to see that it would work with no load. It did once. The second time I got a ground fault alarm and can't get rid of it.
Any ideas at all??
I farted with it for a few hours and had to run.
Maybe tomorrow will bring success.