laminar-flow
Stainless
- Joined
- Jan 26, 2003
- Location
- Pacific Northwest
I have a Haas HPCL lathe and version 8 of the software. When trying to make a G70 pass after a G71 with a feed lower than .001", I get a divide by zero error. A feed of .001" on the G70 block works just fine. I called Haas and they said it was bug in the version 8 with tool nose compensation on.
Any ideas if there is a work around?
Has this showed up on a TL Lathe with version 8 software?
Does switching to Version 9 solve it?
Any ideas if there is a work around?
Has this showed up on a TL Lathe with version 8 software?
Does switching to Version 9 solve it?