wrustle
Titanium
- Joined
- Jun 8, 2006
- Location
- Massachusetts
Ok.....feeling like a complete ass on this one, but as I was waiting for a tool change on my Haas VF-0 I pressed the reset button by accident. The tool is locked into the umbrella and at the same time it clamped into the spindle when I hit the button. Not the "E" stop......the "Reset" button. My question is what do I do now? I'm afraid to touch the machine for fear it will send the "Z" axis home and rip the tool right out of the tool changer. Will the tool changer automatcially return leaving the tool in the spindle if I do an MDI and call for another tool, or is going to rip the tool out of the changer and go to "Z" home to index the changer.
I tried pushing a little on the tool changer to return it home, but the tools are pretty tight in most of the slots this being one of them (Tool#4)
Stupid! Stupid! Stupid!.....I could just scream!
Besides waiting until Tuesday to call Haas........What should I do....take off the rest of the day? If only I could.
Best Regards,
Russ
I tried pushing a little on the tool changer to return it home, but the tools are pretty tight in most of the slots this being one of them (Tool#4)
Stupid! Stupid! Stupid!.....I could just scream!
Besides waiting until Tuesday to call Haas........What should I do....take off the rest of the day? If only I could.
Best Regards,
Russ