brian.pallas
Hot Rolled
- Joined
- Dec 19, 2011
- Location
- Whitehall, MI
I just found out how to get the Haas mills to go to a set posistion whenver M06 or ATC FWD/ ATC REV Button is pushed, using Paramter 210 and Paramter 266 for X axis. But if the Z axis is down by the part, and you do a tool change all three axis move to the tool change posistion at the same time. Does anyone know how to have the Z axis come up first?
(The program itself is set for safe tool change posistion, but sometimes the operator will want to look at a tool and not think about what's going to happen and whack the part or fixture. I also always make it so they just have to go to MDI and push start and it moves to the safe posistion, but......)
(The program itself is set for safe tool change posistion, but sometimes the operator will want to look at a tool and not think about what's going to happen and whack the part or fixture. I also always make it so they just have to go to MDI and push start and it moves to the safe posistion, but......)