Good Afternoon,
This has already been posted in the CNC forum, I'm new to this site, then I came across this HAAS specific page so if you have already read this I apologise
While on a days leave I left a job set up for a guy at work but got a call on my day off to say there was a turret fault, it would appear when he pressed auto off the turret may have still been in the index cycle when he pressed the emergency stop, the turret has now lost position and won't index, has anyone else had similar and is there a quick way the rectify the problem. The fault comes up as Alarm 125.
Update : I am also getting a 114 turret lock fault, I can now get the turret to index but the location pin is 'half the hole' out when trying to engage
Thanks in advance
Nigel
This has already been posted in the CNC forum, I'm new to this site, then I came across this HAAS specific page so if you have already read this I apologise
While on a days leave I left a job set up for a guy at work but got a call on my day off to say there was a turret fault, it would appear when he pressed auto off the turret may have still been in the index cycle when he pressed the emergency stop, the turret has now lost position and won't index, has anyone else had similar and is there a quick way the rectify the problem. The fault comes up as Alarm 125.
Update : I am also getting a 114 turret lock fault, I can now get the turret to index but the location pin is 'half the hole' out when trying to engage
Thanks in advance
Nigel