Hello
I own a Haas TM1P with the next gen controls.
I have a question regarding setting up my tool table.
My machine has a 10 position ATC. I have around 40 toolholders.
I would like to add all the tools with their offset to the table.
But I'm not sure how to do it.
I can setup and call 10 tools.
But when I order a M6 T11 it says the toolnumber is out of range.
It doesn't know in which pocket of the ATC tool 11 is. So how can I specify this?
There is no pocket information in the offset table to specify this.
And I can't imagine I have to measure offset each time I need to use a different tool (a different one than the 10 in the atc).
Because I can't change toolnumbers.
Besides I already lost 1 space to my 3d taster. I can't set it up as tool 50, because it needs to be in the ATC
Or I need to write down the offsets for all my tools.
Load up the atc and manually input the offsets if I want to swap tools.
I own a Haas TM1P with the next gen controls.
I have a question regarding setting up my tool table.
My machine has a 10 position ATC. I have around 40 toolholders.
I would like to add all the tools with their offset to the table.
But I'm not sure how to do it.
I can setup and call 10 tools.
But when I order a M6 T11 it says the toolnumber is out of range.
It doesn't know in which pocket of the ATC tool 11 is. So how can I specify this?
There is no pocket information in the offset table to specify this.
And I can't imagine I have to measure offset each time I need to use a different tool (a different one than the 10 in the atc).
Because I can't change toolnumbers.
Besides I already lost 1 space to my 3d taster. I can't set it up as tool 50, because it needs to be in the ATC
Or I need to write down the offsets for all my tools.
Load up the atc and manually input the offsets if I want to swap tools.