hi, I've been using this machine for couple of months now and started noticing that it developed inconsistencies.
Meaning, it does not return to correct position always.
It mills one part, everything is fine, it mills 10 parts, I notice 0.01mm deviation on a vise, 10 parts more, 0.03mm, two days later, its 0.22mm...
Then I have to calibrate A axis, then it starts all over again.
Is there a way to correct this alignment or encoder issue through parameters? How, which one?
Thanks
Meaning, it does not return to correct position always.
It mills one part, everything is fine, it mills 10 parts, I notice 0.01mm deviation on a vise, 10 parts more, 0.03mm, two days later, its 0.22mm...
Then I have to calibrate A axis, then it starts all over again.
Is there a way to correct this alignment or encoder issue through parameters? How, which one?
Thanks
