have an older Haas, Serial No. 1725, does not have rigid tapping.
At Haas Factory Outlet recommendation, bought a kit. We custom fit & installed the new motor encoder. Hooked up the wiring per the written instructions.
Performed the spindle orientation procedure (ES0650 Rev E) that came with the new encoder.
Reset Parameter 79.
Got code from HAAS to turn Rigid Tapping on (there is a '1' behind Rigid Tapping).
But still NO Rigid tapping.
Spindle will turn on; when reaches the bottom of the stroke, it will not go into reverse, spindle turns off and rapids up.
Can anyone help?
Thanks,
Chuck
[email protected]
At Haas Factory Outlet recommendation, bought a kit. We custom fit & installed the new motor encoder. Hooked up the wiring per the written instructions.
Performed the spindle orientation procedure (ES0650 Rev E) that came with the new encoder.
Reset Parameter 79.
Got code from HAAS to turn Rigid Tapping on (there is a '1' behind Rigid Tapping).
But still NO Rigid tapping.
Spindle will turn on; when reaches the bottom of the stroke, it will not go into reverse, spindle turns off and rapids up.
Can anyone help?
Thanks,
Chuck
[email protected]