Hi,
Just wondering if anyone could shed any light on the correct way to wire in a Renishaw OMI-2H and OMP40-2 to a late 2004 LCD screen VF2SS. I have the probing macros and all required options, found a VQC install manual which describes the wiring for an I/O board without a P77 input, and just using P22 1070 Skip and the M22/M23 spare M relays.
http://www.cam.tuc.gr/DIAFORA JPG/E...n/MANUALS TWN METRHTIKWN/Calibration HAAS.pdf
Also found an OMI SSR to OMI-2H upgrade bulletin using an adapter cable
VS-1/3 - VQCPS - OMI-SSR to OMI-2H Conversion | Haas Automation(R) Resource Center
I'm just a little confused on the correct method to use to get this up and running, and any help would be gladly appreciated, or any photos of control cabinets belonging to machines of similar era with probing installed please?
Just wondering if anyone could shed any light on the correct way to wire in a Renishaw OMI-2H and OMP40-2 to a late 2004 LCD screen VF2SS. I have the probing macros and all required options, found a VQC install manual which describes the wiring for an I/O board without a P77 input, and just using P22 1070 Skip and the M22/M23 spare M relays.
http://www.cam.tuc.gr/DIAFORA JPG/E...n/MANUALS TWN METRHTIKWN/Calibration HAAS.pdf
Also found an OMI SSR to OMI-2H upgrade bulletin using an adapter cable
VS-1/3 - VQCPS - OMI-SSR to OMI-2H Conversion | Haas Automation(R) Resource Center
I'm just a little confused on the correct method to use to get this up and running, and any help would be gladly appreciated, or any photos of control cabinets belonging to machines of similar era with probing installed please?