magno_grail
Hot Rolled
- Joined
- May 29, 2014
- Location
- ca, US
I was profiling a plate clamped to the table (top surface 0.75" above the table). It made one pass 0.050" then hit a 318 Z Over Travel. I changed to a long nose holder so the offset was about 1" higher. As soon as the Z1.0 move was started in the program the 318 error happened again. After trying different offset values I found whenever the tool offset is anything greater than -7.13 the 318 error occurs. Above that value the spindle travels down until is hits the Z stop.
I tried re-homing and power down restart but the problem still occurs.
I can manually move the tool down to where it is below the table surface. I checked the Z limit steps in the parameters and found it was set to the same value as the Y axis. I believe it should be the same as the X axis (20" travel). But that is not the cause of the 318 error.
Any ideas? '91 VF-1
I tried re-homing and power down restart but the problem still occurs.
I can manually move the tool down to where it is below the table surface. I checked the Z limit steps in the parameters and found it was set to the same value as the Y axis. I believe it should be the same as the X axis (20" travel). But that is not the cause of the 318 error.
Any ideas? '91 VF-1