I started noticing that my probing wasn't working right, as in off by .002-.010, so after a half a day of messing with it, it appears that it was some very small chips inside in the rubber folds where the probe meets the body.
I have a hard time understanding why this is the case though, these weren't big enough that I can see them interfering with the mechanism. I'd say they were .002 - .005 x .050 long. Any thoughts why this could be so?
I have a hard time understanding why this is the case though, these weren't big enough that I can see them interfering with the mechanism. I'd say they were .002 - .005 x .050 long. Any thoughts why this could be so?