Hi everyone
I had some down time today and had not recalibrated my tsr27 or probe since I got the Machine. 2006 SMM
I got the length from spindle to bottom of pin and wrote that number down (4.2372)
I then went into VQC and ran all 3 probe setting options.
Tool setter calibration
Spindle probe calibration
XX calibration
So I use the tool setter and set an tool as normal. Probe top of stock. And to test I jog beside the stock and do a midi of g54g00z0.0. Done this many times so I know that part is right.
It goes past my stock and keeps going now so something is not right, what did I miss.
I had some down time today and had not recalibrated my tsr27 or probe since I got the Machine. 2006 SMM
I got the length from spindle to bottom of pin and wrote that number down (4.2372)
I then went into VQC and ran all 3 probe setting options.
Tool setter calibration
Spindle probe calibration
XX calibration
So I use the tool setter and set an tool as normal. Probe top of stock. And to test I jog beside the stock and do a midi of g54g00z0.0. Done this many times so I know that part is right.
It goes past my stock and keeps going now so something is not right, what did I miss.