ARB
Titanium
- Joined
- Dec 7, 2002
- Location
- Granville,NY,USA
1994 VF3
I am getting Alarm 114 "Shuttle Out Fault" just after a tool clamps during a tool change. This is seemingly happening at random. But always right after clamp up. Any ideas? I am thinking that the shuttle out switch is getting a little touchy but that is a guess. Maybe a bad wire somewhere?
Sometimes it will happen about every 4 or 5 tool changes sometimes it is 15-20.
Has anyone run into this and solved it?
Any help would be appreciated.
ARB
I am getting Alarm 114 "Shuttle Out Fault" just after a tool clamps during a tool change. This is seemingly happening at random. But always right after clamp up. Any ideas? I am thinking that the shuttle out switch is getting a little touchy but that is a guess. Maybe a bad wire somewhere?
Sometimes it will happen about every 4 or 5 tool changes sometimes it is 15-20.
Has anyone run into this and solved it?
Any help would be appreciated.
ARB