dcsipo
Diamond
- Joined
- Oct 13, 2014
- Location
- Baldwin, MD/USA
Hi
i need to to make one of these....
12'x x 6' 1"+ depending what cast iron piece i get a hold of.
the front edge 45[SUP]o[/SUP] I will scrape it on all sides. The question comes in, how do i measure the 45[SUP]o[/SUP] on the front to make sure they are perfectly centered and truly 45[SUP]o[/SUP] and parallel to the back. I have a 3" wide 5" sine bar, i think i can balance it on it and set it at 45[SUP]o[/SUP], but i see too many potential errors creeping in. I have a pair of B&S V blocks i could qualify them first and use them but they only have a 2.5" sloping side. I would like to get the whole thing within 2 thenths overall. i know i can scrape to that, but not certain i can measure to that with my setups. Anybody have some oldtimer tricks up their sleeves?
dee
;-D
i need to to make one of these....
12'x x 6' 1"+ depending what cast iron piece i get a hold of.
the front edge 45[SUP]o[/SUP] I will scrape it on all sides. The question comes in, how do i measure the 45[SUP]o[/SUP] on the front to make sure they are perfectly centered and truly 45[SUP]o[/SUP] and parallel to the back. I have a 3" wide 5" sine bar, i think i can balance it on it and set it at 45[SUP]o[/SUP], but i see too many potential errors creeping in. I have a pair of B&S V blocks i could qualify them first and use them but they only have a 2.5" sloping side. I would like to get the whole thing within 2 thenths overall. i know i can scrape to that, but not certain i can measure to that with my setups. Anybody have some oldtimer tricks up their sleeves?
dee
;-D