derekpfeiffer
Plastic
- Joined
- Apr 2, 2017
Hello all! I've been a machinist for 14yrs and 7yrs ago I started a side welding shop. I've been keeping an eye out for a lathe for my shop. Something not too big but not a hobbiest or table top either. I ended up stumbling across a Webb 20.5x60 gab bed lathe. It fit the bill perfectly! I hooked onto my trailer and took off this morning to look at it.
Everything seemed pretty tight. I wasn't able to see it under power. It hadn't been used for years. I ended up picking it up for $3800. Didn't seem too bad for what I got. Wish I could've seen it run first tho. I'm searching for any literature. The sight glass on the back of the machine didn't show any oil. I would like to know what oil goes where on this ol girl!
Hopefully I didn't get sold a bill of goods!
Everything seemed pretty tight. I wasn't able to see it under power. It hadn't been used for years. I ended up picking it up for $3800. Didn't seem too bad for what I got. Wish I could've seen it run first tho. I'm searching for any literature. The sight glass on the back of the machine didn't show any oil. I would like to know what oil goes where on this ol girl!
Hopefully I didn't get sold a bill of goods!