Hi folks, I have a 1987 Mazak QT-8 that I have had for a while, Dont use it much and when it sets for too long without power, of course it looses all parameters, I have all the manuals and the original factory Parameter sheets, Just wanted to test the water and see if there is any interest in it for a retrofit or repair. I have a thread going now, because the spindle will not power up after inputting all the parameters, I forgot to write down all the tool parameters and not sure if that is the problem. Send an e-mail if interested and I can forward pics or answer any other questions on the Forum if you'd like.
[email protected]
[email protected]