What's new
What's new

Bardons & Oliver #2 Turret Lathe

WHHJR

Stainless
Joined
Jun 5, 2009
Location
Near:Louisville, KY
Bardons & Oliver #2 turret lathe with 10' bar feeder. There is a small selection of tooling as shown. The oil pump has been overhauled and works.

The collets range from 1/4 to 1" round with a 49/64 included. There are 3 hex collets also.

The lathe has been rewired with an Automation Direct GS2 VFD operating on 240 VAC 1 PH or 3 PH. Price loaded on your truck at the door $1000.
 

Attachments

  • DSCN3820.jpg
    DSCN3820.jpg
    47.4 KB · Views: 922
  • DSCN3819.jpg
    DSCN3819.jpg
    40.1 KB · Views: 606
  • DSCN3818.jpg
    DSCN3818.jpg
    41.5 KB · Views: 608
  • DSCN3822.jpg
    DSCN3822.jpg
    32.4 KB · Views: 687
  • DSCN3821.jpg
    DSCN3821.jpg
    41.7 KB · Views: 843
Check your eyes. It really is a chainsaw. I'll let it go for an additional $250 and let you have the engine lift in the picture with all of it's parts for another $250. Loaded on your truck of course.

whhjr
 
A great little lathe that needs a new home.

If you were closer!!

Just wanted to add. I picked up a Bardons and Oliver #5 a few years ago and it's a great machine. Heavy and stout. Would make a great addition to a shop that does small production runs.
 
It's all relative I suppose. After commuting for work for the last 14 years I really hate to drive anymore. Anything past Richmond it too far for me. You're about 8 1/2 hours past that :(.

Hope it finds a new home. It's probably a great machine!
 
A bump. I unwrapped the machine over the weekend and powered it. Everything works as it should. Price loaded on your truck or trailer $800.

Do you still have the lathe? I have a road trip next week and can swing by Wednesday or Thursday. Can you load in an F350?

CarlBoyd
 








 
Back
Top