Cincinnati No 2 ML Horizontal mill with universal table. Ser# 5J2U5e-19
This is a heavy duty mill with feeds and rapids on all axis. Seperate feed motor on knee. NMTB 5 taper spindle. With overarm support as pictured. Mill is in fairly good condition over all. A friend bought the mill and took the powered over arm, and replaced with the green arm pictured. I have not run it, but was told that there is something wrong with the spindle speeds under 365 RPM. I looked closely at the parts breakdown and I suspect a gear on the shaft in that speed range.
I was going to mount a Bridgeport head on the overarm and have a solid, full power fed table with enough room to mount two vices. But I dont need another project.
I can load with forklift on site.
Douglas
This is a heavy duty mill with feeds and rapids on all axis. Seperate feed motor on knee. NMTB 5 taper spindle. With overarm support as pictured. Mill is in fairly good condition over all. A friend bought the mill and took the powered over arm, and replaced with the green arm pictured. I have not run it, but was told that there is something wrong with the spindle speeds under 365 RPM. I looked closely at the parts breakdown and I suspect a gear on the shaft in that speed range.
I was going to mount a Bridgeport head on the overarm and have a solid, full power fed table with enough room to mount two vices. But I dont need another project.
I can load with forklift on site.
Douglas
Last edited: