WTB: Feed Trip Dogs for K&T 2CHL

Don Kinzer · Dec 9, 2017

The K&T 2CHL horizontal that I recently picked up has only one of the X-axis table feed trip dogs. Of course, I can make them but if I can get them for a good price it would save me the trouble of doing so. I also need the dogs for the knee vertical travel (Y-axis?).

WHHJR · Dec 10, 2017

Picture please since you have 1.

Hobby Shop · Dec 10, 2017

I picked up a 2HL last week for the HD universal head and parking attachment for my 2CHL. I haven’t put power to it yet but if it turns into a project, I’m scrapping it. If I decide to scrap it, I have one of the knee trips you need. I’ll know what I’m doing with it after the holidays.

Andy

tjs42 · Dec 11, 2017

k& T 2 HL

Hi Don, don't have any trip dogs for a 2HL but have a nice 6" K&T vise that i never use. thought you might be interested. $75 for it. send me a private message if interested.

Don Kinzer · Dec 12, 2017

WHHJR said:
Picture please since you have 1.

Here are some pictures of the one x-axis feed trip dog that I have.

I haven't made a drawing of it yet - just a rough sketch. Perhaps a description will suffice.

The tee-bolt is 7/16 NC with an overall length of 2.375 and the head is 0.726 by 0.770 and 0.190 thick. The key on the dog is 0.437 wide by 0.250 tall and is offset from one side by 0.250 leaving 0.563 on the opposite side. This makes the block 1.250 across the key, 1.625 along the length of the key and 1.125 in the direction of the through hole. The two ramps on the block are 0.375 by 0.375 at the edge and extend to the center of the block making them each about 13/16" long.

Search

Largest Manufacturing Technology Community on the Web

Search

WTB: Feed Trip Dogs for K&T 2CHL

Don Kinzer

Cast Iron

WHHJR

Stainless

Hobby Shop

Stainless

Attachments

tjs42

Hot Rolled

Don Kinzer

Cast Iron

Similar threads