WTS, 1985 Matsuura MC1000V - Fanuc 3000C control with BTR and a LOT of T45 tooling.

1985 Matsuura MC1000V CNC mill with a ton of BT45 tooling including tool setter, right angle head, speeder head, through tool coolant adapter, and much much more.
I will even throw in the very large tool table as I am downsizing back to only having a single building.
40x20x20 travels.
Fanuc 3000C control and BTR works fine most of the time but has occasional glitches I have always been able to eventually sort out.
Currently has a tool changer issue, arm swings into place but does not extend.
May be as simple as a capacitor on the solenoid or a loose wire.
If you know basic machine troubleshooting it should be a simple fix.
Manuals included.
I am currently using it in manual mode for couple more days.
Weighs 16000 pounds, a very rigid machine.
Take it all for less than the value of the tooling, $2500.00 cash.
No vice included.
May also be selling my Fadal 15 and Milacron 208U in the late fall, have not decided for sure yet.

Gardnerville Nevada, fifty miles south of Reno.

Richard, (775) 78THREE-FOUR867
PM or email are good too.

Well, looks like if the #$&!@ thunderstorms ever let up I will make another run at repair.
Have a small job for the Matsuura if I can get it running again.
Just used it as a big manual machine for some deep slotting.