Thread: looking to have parts made

Looking to have these made out of aluminum.

How many do you want?

looking for atleast 8

Shipping from here to PA would cost more than the parts themselves.

Originally Posted by jkruger

Shipping from here to PA would cost more than the parts themselves.

how much would the parts be ?

I think Mr. Kruger was being facetious.

PM sent
Thank You

Originally Posted by aerodark

I think Mr. Kruger was being facetious.

Indeed I was.

I can doit for you send me a pm.

Still looking to have these parts made. Looking to have 8 of each made. Was offered to have them made for $100 by a local member but communication was lost. Can anyone help?

Hello,

I'll send you an e-mail. I can make these for you, if you can wait a week or two. Not sure I can do them for $100 though .

Regards.

Mike

Tolerance? I'm highly suspecting the round figures to a thousandth aren't +\- 5 tenths. I'm always lost how folks quote without a comprehensive tolerance figure to the basic drawing.

Originally Posted by Arthur.Marks

Tolerance? I'm highly suspecting the round figures to a thousandth aren't +\- 5 tenths. I'm always lost how folks quote without a comprehensive tolerance figure to the basic drawing.

In the "Napkin drawing club"(Which i happen to be a member), i assume that anyone who asks for a quote without adding tolerances to the drawings isn't looking for a high tolerance part. I always just ask for critical tolerences, if there is any before quoting. Most of the time i make parts for a customer like this, tight tolerence isn't an issue. For simple parts with hand drawings and such, i always make sure to ask, and make notes.

Originally Posted by RUBZERK

Still looking to have these parts made. Looking to have 8 of each made. Was offered to have them made for $100 by a local member but communication was lost. Can anyone help?

Probably cause he went out of business already. $100 is a good price for 1...

Is it me or do the views of the drawing not make sense? Particularly the side views.

Originally Posted by ss_again

Is it me or do the views of the drawing not make sense? Particularly the side views.

I assume it is 2 parts, one long one short.

Originally Posted by robert123

I assume it is 2 parts, one long one short.

that is correct, there is 2 parts there. here is what they are for. motorcycle fender extenders. used to raise the fender to accommodate a larger tire.

I would like to quote the job but I am interested in what the tolerances are.

thanks
Aaron

tolerance is .010

would like to have them made out of 6061 aluminum.

Check your PM's here. I quoted this right after you posted it.




Frank