ranchak
Cast Iron
- Joined
- Dec 4, 2007
- Location
- Southern California
I need some parts for a LuxCut 1136 lathe. I've tried Enco, but haven't had any luck. Any ideas?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
LuxCut parts needed
- Thread starter ranchak
- Start date
- Replies 5
- Views 4,546
Finegrain
Diamond
- Joined
- Sep 6, 2007
- Location
- Seattle, Washington
What kind of parts?
FG
FG
ranchak
Cast Iron
- Joined
- Dec 4, 2007
- Location
- Southern California
I need the worm gear and worm for the apron, eventually a new lead screw for the apron, the back drive gear, the main pulley bracket and a few other small parts.
Finegrain
Diamond
- Joined
- Sep 6, 2007
- Location
- Seattle, Washington
Oh. Easy stuff 
.
I think you will pay less for a new 11x36 import lathe then you will for those parts.
Regards.
Finegrain
.I think you will pay less for a new 11x36 import lathe then you will for those parts.
Regards.
Finegrain
ranchak
Cast Iron
- Joined
- Dec 4, 2007
- Location
- Southern California
Actually the cost of the parts (although they won't fit my machine) through Enco where very reasonable. The most expensive was the lead screw at $161. I can make the worm gear and I really don't need the back gear. I have a frequency inventer and I can reverse the motor with it. I just wanted to replace these items while I have the lathe down for repairs.
Hammerhead800
Plastic
- Joined
- Apr 7, 2017
You don't happen to have a back gear cluster for an 1136 laying around would you?
