I'm looking at getting some prototypes done (qty 2). It's not a complicated part, just some ID turning work in 2" OD, 6.5" long aluminum round bar. Key features are a 1.062" through bore, 1.25" bore 4" deep from one end and a 1"-11 NPSM thread 1" deep on the other end.
Unfortunately, I'm not well set up for turning. This should be an easy job if you're tooled for it, but most of my work is mill work.
PM me with your e-mail address if you're interested and I'll send the print. I'd like delivery in the sub-2 week timeframe, but I can be flexible.
Unfortunately, I'm not well set up for turning. This should be an easy job if you're tooled for it, but most of my work is mill work.
PM me with your e-mail address if you're interested and I'll send the print. I'd like delivery in the sub-2 week timeframe, but I can be flexible.