Pat G
Hot Rolled
- Joined
- Apr 12, 2009
- Location
- California
I need PVC collars turned and drilled with a 1/2-13 tapped hole as shown, but a smooth nice finish on the OD and ID.
I will be ordering these on a continual basis, and anticipate large numbers in the near future. Possibly in the thousands.
I have a .pdf file spec sheet I can send.
This was turned out of 1 5/8" OD round grey PVC stock, and that stock can be used, and turned down just enough to make a nice finish on the OD.
Aproxx 1.175" long. ID .978". Forgot to mention generous tolerances +/- .005"
I need 250 to start, shipped USPS Priority Flat Rate.
Please send a PM with email and your info.
Thanks much,
Pat
I will be ordering these on a continual basis, and anticipate large numbers in the near future. Possibly in the thousands.
I have a .pdf file spec sheet I can send.
This was turned out of 1 5/8" OD round grey PVC stock, and that stock can be used, and turned down just enough to make a nice finish on the OD.
Aproxx 1.175" long. ID .978". Forgot to mention generous tolerances +/- .005"
I need 250 to start, shipped USPS Priority Flat Rate.
Please send a PM with email and your info.
Thanks much,
Pat