RFQ WEDM some slots in 17-4 parts, PNW area

Finegrain · May 31, 2017

Hello,

I'd like to get quotes on making this slot in 12 pieces of 17-4 Cond H1150. The slot goes thru the 17.5mm part width, and the part is 41mm tall:

Might have to be a PNW shop, as I have a short deadline to deliver finished parts.

Thanks, and regards.

Mike

*** On edit -- PO was cancelled, no longer need this work done. Thanks for the tips above though, I appreciate it. ***

Jay Fleming · May 31, 2017

Not sure if he reads the this section but "implmex" Marcus, has a website vancouverwireedm.com I believe. I know nothing about him, just always see it posted in his replies.

Sent from my HTC One using Tapatalk

Zahnrad Kopf · May 31, 2017

Feel free to email me, M. FedEx makes the world a whole lot smaller at times.

Matt@RFR · May 31, 2017

Finegrain said:
Might have to be a PNW shop, as I have a short deadline to deliver finished parts.

Not what you asked for, but this is no problem to do in house. Drill with 3mm or whatever you have, use a Harvey #34693-C3, HSM that bad mamma jamma out and maybe use a separate finisher of the same tool if you feel like it. 8xD endmills are nothing to be frightened of.

Finegrain · May 31, 2017

Thanks for those who looked, but my PO was cancelled so I no longer need this work done.

Regards.

Mike

Search

Largest Manufacturing Technology Community on the Web

Search

RFQ WEDM some slots in 17-4 parts, PNW area

Finegrain

Diamond

Attachments

Jay Fleming

Hot Rolled

Zahnrad Kopf

Diamond

Matt@RFR

Titanium

Finegrain

Diamond

Similar threads