Mazak Multiplex T32-6

I have this machine on the floor, sent from a sister company running one particular job. I'm putting another job in there now and when watching the machinist run the first piece, I see him running from the position screen. I'm told this is the only place they can see the program execute and it's one line at a time on Top Right. I gave him a program where each section had 1 N number, i.e. N0001 T101, N0002 T303 and he couldn't use it because the only way he knows where he is at is by the N number. This is worse than the old Allen Bradley controls. I have to believe that were missing something here. He called up the program page and cycle started the program and the machine started but the program was not tracking with the machine. I assume there are others in the forum that have this machine, is there parameters that control the operators panel?

Thanks,

Bob

I have the same machine but I dont understand your problem?