cwtoyota
Cast Iron
- Joined
- Feb 11, 2010
- Location
- Washington State
I'm trying to connect MazView's demo to my QT10N with T2-CAM control before I purchase the full software.
What settings and parameters should I be concerned with to make this work?
Do I need to connect to the port on the right hand side of the operator panel, or the port on the left?
I have successfully transferred EIA/ISO through the port on the left using 4800 baud and the same setup I use on Fanuc machines.
Thanks!
What settings and parameters should I be concerned with to make this work?
Do I need to connect to the port on the right hand side of the operator panel, or the port on the left?
I have successfully transferred EIA/ISO through the port on the left using 4800 baud and the same setup I use on Fanuc machines.
Thanks!