What's new
What's new

Cuttoff chamfer help cam t-2

blgmachine

Cast Iron
Joined
Feb 16, 2010
Location
Wisconsin
MAKING A FEW THOUSAND PINS WITH 45 DEGREE BY .06 NON BOTH SIDES.
USING THE #1 OPTION IN GROOVE MODE,BUT I AM GETTING A 55 DEGREE ON PART PIECE AND 45 ON BAR.
USING NEUTRAL CUTOFF TIP.
WHERE IS MY PROBLEM?

THANKS Gus
 
NO NEED FOR THIS.

Check your tool data, watch it on the screen. I'm quite sure you're tool data isn't correct because it sounds like the controller wants to do a 45 but thinks it cannot because of tool data.

Also are you just using a finish pass somehow or what?

If your just doing a rough its leaving stock.. Are you programming just a groove them a cutoff?


Edit: its 100% incorrect tooldata if it's putting a 45 on the stock.
 
THANKS LYK
WENT WITH FIRST CUTTING SHALLOW GROOVE SO IT COULD ROUGH AND FINISH,THEN TO A SECOND GROOVE THAT DOES THE CUT OFF.
ALL IS WELL NOW

THANKS Gus
 








 
Back
Top