Hello Forum
I am looking for someone with a GL-200N Gantry System. My problem is that someone removed the AMP Board and Main Control Board from the system. I have managed to get the most of the wiring and the boards re-installed however there are a few wires that I have not figured out. I have no idea where the PON, POC terminate nor the ON/POC Jumper from the schematics I have in hand. See the attached schematic.
Hoping someone can take a photo of their board so I can figure out where these wires terminate
Kind Regards
Romefu12
I am looking for someone with a GL-200N Gantry System. My problem is that someone removed the AMP Board and Main Control Board from the system. I have managed to get the most of the wiring and the boards re-installed however there are a few wires that I have not figured out. I have no idea where the PON, POC terminate nor the ON/POC Jumper from the schematics I have in hand. See the attached schematic.
Hoping someone can take a photo of their board so I can figure out where these wires terminate
Kind Regards
Romefu12
