Panza
Stainless
- Joined
- Oct 23, 2005
- Location
- Lillehammer, Norway
Although I have read the programming manual there seems to be no good explanation on how to set the approach points when programming a milling unit on a lathe with live tools.
First: What does the numbers/coordinates of the AP's relate too ? It'd not coordinates as in the rest of the program that I can see.
Second: How do you figure out how you set them manually.
I'd say this is the problem I have the most often when programming.
First: What does the numbers/coordinates of the AP's relate too ? It'd not coordinates as in the rest of the program that I can see.
Second: How do you figure out how you set them manually.
I'd say this is the problem I have the most often when programming.