Hillbillyhalfton
Plastic
- Joined
- Mar 15, 2018
Apologies if I’ve posted in the wrong place or if this has been covered before. I searched and do not find what I was looking for.
The machine involved is a 510c with matrix controller. I am hoping someone can help me out with an adjustment to the rapid feed rate on this machine. Long story short, I have an operator that I’ve caught several times with the rapid feed rate turned down to 50%. I am looking for a way to override the override so to speak. I know parameter M1 controls the rapid feed rate. And I know I can change R0, R1, R2 in the PLC. Is there any way, perhaps in privilege mode to change only the 50% rapid feed rate and make it equal to 100% (totally eliminating 50%)?
This way the machine could only be ran on 100% or 25% where the production numbers would take a large decrease forcing the operator to run only at 100%.
Any other suggestions welcomed (firing is not an option). Thanks for any and all help!
The machine involved is a 510c with matrix controller. I am hoping someone can help me out with an adjustment to the rapid feed rate on this machine. Long story short, I have an operator that I’ve caught several times with the rapid feed rate turned down to 50%. I am looking for a way to override the override so to speak. I know parameter M1 controls the rapid feed rate. And I know I can change R0, R1, R2 in the PLC. Is there any way, perhaps in privilege mode to change only the 50% rapid feed rate and make it equal to 100% (totally eliminating 50%)?
This way the machine could only be ran on 100% or 25% where the production numbers would take a large decrease forcing the operator to run only at 100%.
Any other suggestions welcomed (firing is not an option). Thanks for any and all help!